Warning
For professional installer use only.
Step 1
If contaminated, use a clay bar to clean the paint. If paint correction is required do so before application. Residues will need to be removed.
Step 2
Wash and completely dry surfaces to be coated. Using dish detergent or by adding all purpose cleaner to car soap.
Step 3
Clean the paint using a 50% IPA (isopropyl alcohol) to water mix in a trigger sprayer. Mist the paint then wipe down with a microfiber towel.
Step 4
Wipe on coating by hand using a sponge or coating block, panel by panel. After wiping on wait 30-90 seconds to flash (depending on temp) then buff off with a microfiber towel. Flash times vary with climate.
Step 5
Layers should be 15 to 20 minutes apart. Wait 20 minutes before driving, and 24 – 48 hours before getting wet.